POWER FLUSHING

Have you noticed any of the following problems with your central heating system?

Taking a long time to heat up?

Cold areas on radiators?

Dark water from radiators when bleeding?

POWER FLUSHING IS AN EXCELLENT WAY OF:

Remove sludge built up in a heating system over time.

Clean the heat exchanger in a boiler to improve efficiency.

Improve the overall efficiency of your heating system.

HOW IT WORKS

We use a specialised power flushing pump.

Normally, a chemical cleaning solution is added to the heating system a week or so prior to the powerflush. During this time, you will use your heating as normal, the chemical will break down the sludge deposits within the heating system.

The power flushing pump is connected into the heating system, either across standard circulator pump couplings, across the tails of one radiator, or wherever most practicable. The powerful flow, combined with instantaneous flow reverser device, will dislodge and mobilise deposits and corrosion which resist traditional system cleaning methods.

Once the corrosion and sludge deposits have been loosened and mobilised, fresh clean water is forced through the heating system, pushing the contaminated water out through a full-bore dump valve to waste. During the powerflushing process, radiators are individually flushed, without removing or disconnecting them from the system, by directing the full output of the pump through each radiator separately.

At the end of the flushing process, the system contains fresh clean water and reinstatement of the system to normal operation takes only a few minutes. A chemical inhibitor is added at the end of the process to reduce any future corrosion.

System flushing will not remedy design or mechanical faults, which should be rectified, but in many cases, it will cure the problems caused by these.